RedFlag

[1] How to use tile press equipment

How to use the tile press equipment, the customer's usage process, and the preparation work before application, let's briefly explain below.

Before using the machine, customers should check and prepare well, improve the protective steps, and then correctly check whether the upper and lower molds are firmly matched during use. Then, check the positioning devices at each point and whether they meet the processing requirements. Before use, all parts should be returned to their original positions. In order to eliminate any unnecessary faults, the machine should be idle for 1 to 2 minutes before use, Then, when it is confirmed that there are no problems, proceed to the next step of operation. During the operation, a single person will provide unified command and operation. The operator carefully listens to the command for correct operation. After use, shut down the machine in the correct order.

[2] How to correctly debug the tile pressing machine

How should we debug our tile press after it is installed? Here's how to correctly debug the tile press:

1、 Control cabinet panel

1. The oil pump switch is used to control the start and stop of the oil pump. Before running, please turn on the oil pump to provide pressure to the hydraulic system. After the oil pump is running, pay attention to whether the direction of the oil pump should be consistent with the direction of the arrow. If there is any inconsistency, please replace any two three-phase motors in the oil pump motor with each other.

2. The down cutting and return buttons control the operation of the cutting tool. If pressing the cut and return buttons is ineffective, it is generally necessary to consider whether the oil level in the hydraulic oil tank is too low and supplement hydraulic oil to the empty tank. In addition, during the process of cutting and returning the cutting knife, the operation of the limit switch in front will automatically stop.

3. The forward and reverse operation of the host is controlled by a frequency converter, and its speed can be controlled by the high/low speed switch on the panel. Be sure to place the speed switch at high speed during automatic operation.

4. The user first needs to set the length value and planned number, then use the [Select] key to select the running option, and then press the [OK] key to achieve automatic operation. Start running when the completion count is less than the plan, and the system runs until the two are equal; Start operation when the completion number is greater than or equal to the planned number, and automatically stop after rolling only one plate and cutting it. Press the [Reset] button to stop the vehicle.

5. If the engine is started and running, the main engine will not run, and the display screen will display an up arrow, indicating that the cutting tool is not reaching the upper limit. Please turn on the oil pump, and the cutting tool will automatically move up to the desired position. The main engine will start running. If the host does not enter low speed operation 150 millimeters before parking, it will not be able to achieve plate rolling accuracy.


Contact email:

1637332238@qq.com

Contact number:

13831793799 (same WeChat account)

13831765199 (same WeChat account)

13831775266 (same WeChat account)

13832730199 (same WeChat account)

13832705299 (same WeChat account)

13803257566 (same WeChat account)

13831703899 (same WeChat account)