Refer to the following placement points:
(1) For convenient maintenance and repair, please be at least 50cm away from the wall
(2) Then make precise adjustments: the machine rack must be leveled to maintain precision
(3) Secondly, for the installation of the foundation, it is important to note the following: a The strength must be able to follow the weight of the machine; b The base surface must be flat
(4) Installation of color steel equipment (refer to the manual)
(5) After that, there should be a place with good power supply
There are two fixing methods for the installation of color steel tile pressing machine equipment: penetrating and concealed. Penetrating fixing is a common method for installing color steel equipment on roofs and walls, which is to use self tapping screws or rivets to fix the color plate on the support components (such as purlins). The construction technology and operating points of color steel tile pressing equipment
1、 There are two fixing methods for the installation of color steel tile pressing machine equipment: penetrating and concealed. Penetration fixation is a commonly used method for installing colored steel equipment on roofs and walls, which involves using self tapping screws or rivets to fix the color plate to a support member (such as a purlin). Penetration fixation can be divided into peak fixation, trough fixation, or a combination of them. Concealed fastening with concealed buckles is a method of fixing the specially made concealed buckles that are matched with the concealed buckled color board to the supporting components (such as purlins), and the mother rib of the color board is toothed with the center rib of the concealed buckle. It is generally used for the installation of roof panels.
2、 Overlap the side and end of the color board. When installing each steel plate, its edges should be accurately overlapped and placed on the previous steel plate, and clamped with the previous steel plate until both ends of the steel plate are fixed. A simple and effective method is to use a pair of pliers to clamp the overlapping steel plates separately.
3、 In the south, color panels are generally designed as single-layer color panels. In order to reduce the entry of solar radiation heat into the interior of buildings, insulation layers can be installed in the roof system when installing roof panels. A very simple, economical and effective method is to lay a double-sided reflective foil film on the purlin or Flat noodles before installing the roof steel plate. This method can also be used as steam isolation to reduce condensation. If the sagging depth of the film between the supports is allowed to reach 50-75mm, the air layer between the film and the roof panel will further improve the insulation effect.
Contact email: 1637332238@qq.com
Contact number: 13831793799 (same WeChat account)
13831765199 (same WeChat account)
13831775266 (same WeChat account)
thirteen billion eight hundred and thirty-two million seven hundred and thirty thousand one hundred and ninety-nine
thirteen billion eight hundred and thirty-two million seven hundred and five thousand two hundred and ninety-nine
thirteen billion eight hundred and three million two hundred and fifty-seven thousand five hundred and sixty-six
thirteen billion eight hundred and thirty-one million seven hundred and three thousand eight hundred and ninety-nine